Tag Archives: Lotus Flower Extract

Lotus Flower & Nettle Hair Conditioner

 

Ingredients:

55 oz Distilled Water

4.30 oz BTMS-50

.84 oz Panthenol-DL

.84 oz Hemp Seed Oil

1 oz Nettle Extract

1 oz Lotus Flower Extract

Preservative. (I am using Optiphen ND at 1%)

Instruction:

In a double Boiler melt the BTMS-50 and hemp seed oil. In a mixing bowl as your distilled water and heat in the microwave until it’s about 120-140 degrees. Remove an oz of water and dissolve the Panthenol-DL.

Once everything is hot and the BTMS-50 is melted and completely clear, mix them together slowly while whisking constantly. Once fully incorporated continue to mix for 30 seconds then add the Panthenol-DL/water and whisk. Once incorporated add the Nettle Extract and mix until incorporated, Add the Lotus Flower Extract and whisk for one minute. Let the bowl rest for about 5 minutes and whisk again, add fragrance and preservative and whisk for one minute. I used a tart apple fragrance. After all ingredients are mixed use a pH test strip (you want to be between 5-6.) You will need to adjust if you are outside of that range. Citric Acid is used to increase acidity.

Also important to note that I am using Optiphen ND which causes my conditioner to thin  when I add it so before adding it you should have a fairly thick conditioner, if you are using a different preservative you may need to adjust your water or BTMS-50 ratio quickly. With any new recipe (most of the time for me) I have the new recipe back-up ingredients ready on the side: some extra hot water and some extra BTMS-50  that is ready to quick melt, just in case my conditioner is too thick or too thin.

Continue whisking for a few minutes. After the preservative is added no new ingredients should be introduced. Test your conditioner with a pH test strip. It should be in the 5-6 range. Let your mixture rest for 5 minutes then whisk again on and off for at least 5 cycles or until the conditioner is just slightly warm. Bottle the conditioner when it is still warm, it’s thinner and easier to work with the warmer it is. You also need to ensure you have a good emulsion so it doesn’t separate so do not skip the whisk and wait steps, I like using a glass bowl so I can see if there is separation.

I find a turkey baster works well for bottling conditioner and bottling at a hotter temperature is best for thicker conditioners. Leave the containers with the lids off, until they reach room temperature, this prevents condensation.